Thursday, August 22, 2019

Wing Tie Down Bracket Fab

 Started by marking the tie down bracket extrusions for cut to length.

 Then I cut them on the band saw.

 Then I marked and drilled the pilot hole.  I went ahead and mirrored the left one and started a right one.

 Then I drilled and tapped the bottom end.

 All tapped.

 Then I attached them to the spars and match drilled them to the spar.


 I then match drilled the #12 bolt holes.


 All drilled...


 Deburred all the holes.

Deburred the brackets.

No comments:

Post a Comment