Elevator Skin Deburing

Today I finished deburring all of the elevator skin holes and edges.

 First I knocked out these elevator hinge doublers.  Deburred the holes.

 And cleaned up the edges on the big scotchbrite wheel.

 Next I pulled the blue film from the outside surfaces of all the elevator skins.

 Then deburred all the holes in the skins.  There are a ton of holes!

 And then cleaned up all the edges of the skins using files, emery cloth, scotchbrite pads and these roloc pads on a die grinder.  Works great, just takes time!

Then I covered up the edge where the AEX trailing edge wedge piece goes and also covered the area where the foam ribs get pro-sealed into the assembly.