Elevator Deburring

Lots of deburring of the left elevator parts tonight.

 This pile of parts got the large scotchbrite wheel treatment tonight.  Next is fine deburring around the larger holes, flange notches, and then final hole deburring.

 I also did the countersinking of the inboard 29 holes on the top of the rear spar for the left elevator.  The countersinks go deeper than the spar is thick so you need to back up the cutter with some scrap.  Easy enough....

 The reason these holes are countersunk is because the elevator trim tab hinge gets riveted to the underside of the rear spar's top flange.  The skin dimples fit into the countersink so the hinge can sit flush on the spar flange.  The hinge is really soft stuff that would be hard to dimple and rivet properly so it remains flat.

Done....